Section 43 (Rear Axle - Evolution)
WARNING: This page is about a different variant/trim than selected.
- General Description
- Rear Axle Diagnosis
- Introduction
- Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Noise During Wheel Rotation < Drive Shaft >
- Inspection Procedure 2: Constant Noise < Differential >
- Inspection Procedure 3: Gear Noise While Driving< Differential >
- Inspection Procedure 4: Gear Noise While Coasting < Differential >
- Inspection Procedure 5: Bearing Noise While Driving Or Coasting < Differential >
- Inspection Procedure 6: Noise While Turning < Differential >
- Inspection Procedure 7: Heat < Differential >
- Inspection Procedure 8: Oil Leakage < Differential >
- Special Tools
- On-Vehicle Service
- Rear Axle Hub Assembly
- Knuckle
- Drive Shaft Assembly
- Differential Carrier Assembly
- Removal And Installation
- Differential Support Member Bushing Replacement
- Disassembly (Carrier)
- Notes
- Inspection Before Disassembly
- Final Drive Gear Backlash
- Drive Gear RUNOUT
- Final Drive Gear Tooth Contact
- Disassembly Service Points
- << A >> Differential Case Assembly/Differential Side Bearing Spacer/Differential Side Bearing Outer Race Removal
- << B >> Differential Side Bearing Inner Race Removal
- << C >> Drive Gear Removal
- << D >> Self-Locking Nut Removal
- << E >> Drive Pinion Assembly/Companion Flange Removal
- << F >> Drive Pinion Rear Bearing Inner Race Removal
- << G >> Oil Seal/Drive Pinion Front Bearing Inner Race/Drive Pinion Front Bearing Outer Race Removal
- << H >> Drive Pinion Rear Bearing Outer Race Removal
- Assembly (Carrier)
- Notes
- Lubrication And Adhesive Points
- Assembly Service Points
- >> A << Oil Seal Press-Fitting
- >> B << Drive Pinion Rear Bearing Outer Race Press-Fitting
- >> C << Drive Pinion Front Bearing Outer Race Press-Fitting
- >> D << Drive Pinion Height Adjustment
- >> E << Drive Pinion Turning Torque Adjustment/Oil Seal Installation
- >> F << Drive Gear Installation
- >> G << Differential Side Bearing Inner Race Installation
- >> H << Bearing Cap Installation/Final Drive Gear Backlash Adjustment
- Disassembly And Assembly (Case)
- Inspection
- Specifications