Troubleshooting Guide

The starting system troubleshooting guide is shown in the following steps.

WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.

STEP 1.
Q: Is the battery in good condition? (Refer to BATTERY CHECK .)
- YES: Go to Step 2.
- NO: Charge or replace the battery.
STEP 2.
- Disconnect the starter motor S (solenoid) terminal connector.
- Using a jumper wire, apply battery positive voltage to the starter motor S (solenoid) terminal.
- Check the engine condition.
  OK: Turns normally
Q: Dose the starter motor operate normally?
- YES:
  - Check the ignition switch (Refer to INSPECTION .)
  - Check the transmission range switch. (Refer to TRANSMISSION RANGE SWITCH CHECK .)
  - Check the line between the battery and starter motor S (solenoid) terminal.
- NO: Go to Step 3.
STEP 3.
- Check the cable between starter B (battery) terminal and battery positive terminal for connection and continuity.
Q: Is the starter cable in good condition?
- YES: Go to Step 4.
- NO: Repair or replace the cable.
STEP 4.
- Check the connection and the continuity of the cable between the starter motor body and the negative battery terminal.
Q: Is the ground line in good condition?
- YES: Go to Step 5.
- NO: Repair or replace the cable.
STEP 5.
Q: Is the starter motor in good condition? (Refer to STARTER MOTOR ASSEMBLY ).
- YES: Excessive rotational resistance of the engine.
- NO: Replace the starter motor.