Section 1 (General - Lancer)
WARNING: This page is about a different variant/trim than selected.
- How To Use This Information
- Troubleshooting Guidelines
- How To Use Troubleshooting/Inspection Service Points
- Troubleshooting Contents
- Standard Flow Of Diagnostic Troubleshooting
- System Operation And Symptom Verification Tests
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Symptom Chart
- Diagnostic Trouble Code Procedures
- Symptom Procedures
- Service Data Reference Table
- Check At Ecu Terminals
- Inspection Procedures Using An Oscilloscope
- How To Use The Inspection Procedures
- Harness Inspection
- Measures To Take After Replacing The Ecu
- Connector Measurement Service Points
- If Inspecting With The Connector Connected < Waterproof Connectors >
- If Inspecting With The Connector Connected < Ordinary (Non-Waterproof) Connectors >
- If Inspecting With The Connector Disconnected < When Inspecting A Female Pin >
- If Inspecting With The Connector Disconnected < When Inspecting A Male Pin >
- Connector Inspection Service Points Visual Inspection
- Connector Pin Inspection
- Connector Engagement Inspection
- How To Cope With Intermittent Malfunctions
- To Cope With Intermittent Malfunction
- Simulation Tests
- Inspection Service Points For A Blown Fuse
- Vehicle Identification
- Precautions Before Service
- Towing And Hoisting
- General Data And Specifications
- Tightening Torque
- Lubrication And Maintenance
- Recommended Lubricants And Lubricant Capacities Table
- Scheduled Maintenance Table
- Maintenance Service
- 1. Fuel System (Tank, Pipe Line And Connection, And Fuel Tank Filler Tube Cap) (Check For Leaks)
- 2. Fuel Hoses (Check Condition)
- 3. Air Cleaner Element (Replace)
- 4. Evaporative Emission Control System (Except Evaporative Emission Canister) (Check For Clogging)
- 5. Spark Plugs (Replace)
- 6. Intake And Exhaust Valve Clearance (4G6-MIVEC Engine Only) (Inspect And Adjust)
- 7. Timing Belt (Replace)
- 8. Drive Belt (For Generator, Power Steering Oil Pump) (Check Condition)
- 9. Exhaust System (Connection Portion Of Muffler, Muffler Pipes And Converter Heat Shields) (Check And Service As Required)
- 10. Engine Oil (Change)
- 11. Engine Oil Filter (Replace)
- 12. Manual Transaxle Oil
- 13. Automatic Transaxle Fluid
- 14. Engine Coolant (Change)
- 15. Coolant Hoses (Radiator Hose, Heater Hose) (Inspect)
- 16. Disc Brake Pads (Inspect For Wear)
- 17. Rear Drum Brake Linings And Rear Wheel Cylinders (Inspect For Wear And Leaks)
- 18. Brake Hoses (Check For Deterioration Or Leaks)
- 19. Ball Joint And Steering Linkage Seals (Inspect For Grease Leaks And Damage)
- 20. Drive Shaft Boots (Inspect For Grease Leaks And Damage)
- 21. Suspension System (Inspect For Looseness And Damage)
- 22. Tires (Rotate)
- 23. Air Filter (Replace)
- Main Sealant And Adhesive Table