FixVault
Home › Mitsubishi › 2011 › Endeavor LS, AWD › Repair and Diagnosis › Electrical › Gauges › Combination Meter Assembly And Vehicle Speed Sensor › On-Vehicle Service › Fuel Level Sensor Check › Fuel Level Sensor Resistance

Fuel Level Sensor Resistance

  1. Remove the fuel pump module and fuel level sensor (sub) (Refer to FUEL TANK .).
  2. Check the resistances between fuel level sensor main terminals 1 and 2 as well as sub terminals 1 and 2 of the fuel pump module, respectively.

    Standard value: 

    STANDARD VALUE CHART

    ITEM FUEL LEVEL SENSOR (main) FUEL LEVEL SENSOR (sub)
    Resistance Ω Point "F" (highest) 6.5 6.5 ± 1.0
    Point "E" (lowest) 36.0 84.0 ± 1.0
  3. Check that resistance value changes smoothly when the float moves slowly between points.
  4. If all checks are correct, go to FUEL UNIT HEIGHT CHECK . If any check is not correct, replace the fuel pump module or fuel level sensor (sub).
    Fig 1: Checking Resistances Between Fuel Level Sensor Terminals 1 And 2
    G06700517Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
About FixVault