Additional Service When Replacing TCM: Procedure

CHECK WORK CONTENTS
Replacing only the TCM: GO TO 2.

Replacing the TCM after the transaxle assembly is replaced: GO TO 2.

Replacing the transaxle assembly after the TCM is replaced: GO TO 5.
LOADING OF CALIBRATION DATA
1. Shift the selector lever to the "P" position.
2. Turn ignition switch ON.
3. Check that "P" is displayed on shift position indicator on combination meter.
  NOTE: Displayed approximately 4 - 5 seconds after the selector lever is moved to the "P" position.
  
  Does the shift position indicator display "P"?
  
  YES: GO TO 3.
  
  NO: GO TO 4.
PERFORM CALIBRATION OF G SENSOR
Refer to "PROCEDURE ".

: WORK END
LOADING OF CALIBRATION DATA
Check the following items:
- Harness between the TCM and the ROM assembly inside the transaxle assembly is open or shorted.
- Disconnected, loose, bent, collapsed, or otherwise abnormal connector housing terminals
  Is the inspection result normal?
  
  YES: GO TO 2.
  
  NO: Repair or replace the malfunctioning parts.
PERFORM CALIBRATION OF G SENSOR
Refer to "PROCEDURE ".

: Perform "ADDITIONAL SERVICE WHEN REPLACING TRANSAXLE ASSEMBLY " after "CALIBRATION OF G SENSOR". Refer to "PROCEDURE ".