Additional Service When Replacing Control Valve Or Transaxle Assembly: Description

Perform the following work after the control valve or transaxle assembly is replaced. For work procedure, refer to Work Procedure .

ERASING, LOADING, AND STORING OF CALIBRATION DATA

• The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the ROM assembly (in the control valve). This enables the TCM to perform accurate control. For this reason, after the control valve or transaxle assembly is replaced, it is necessary to erase the calibration data previously stored in TCM, to load new calibration data, and to store them.

ERASING OF LEARNED VALUE DATA

• TCM learns indicated pressure for appropriate control of the transaxle assembly and records the learned values. For this reason, the leaned values stored in TCM must be erased after replacing a control valve or transaxle assembly.