FixVault
Home › Pontiac › 2005 › Aztek Base, AWD › Repair and Diagnosis › Brakes › Antilock Brake System And Traction Control System › Diagnostic Information and Procedures › DTC C0141-C0156 › Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 2:  This step determines if the DTC is current.
DTC C0141-C0156

Step Action Yes No
Schematic Reference: ABS Schematics 
Connector End View Reference: ABS Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Using a scan tool clear the DTC.
  2. Remove the scan tool from the DLC.
  3. Carefully drive the vehicle above 12 km/h (8 mph) for several minutes.
  4. Turn the ignition switch to the OFF position.
  5. Install a scan tool.
  6. Turn the ignition switch to the ON position, engine off.
  7. Using the scan tool in Diagnostic Trouble Codes, check for DTCs.
Did any one of the DTCs C0141-C0151 reset as a current DTC?		 Go to Step 3  Go to Diagnostic Aids
3 Replace the electronic brake control module (EBCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Is the repair complete?		 Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
About FixVault