FixVault
Home › Pontiac › 2005 › G6 Base › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - Introduction & Repair Instructions › Repair Instructions › Shift Control Cable Replacement - Floor Shift › Removal Procedure

Removal Procedure

    Fig 1: Pressing Tabs On Control Cable And Removing Cable From Control Assembly
    GM1518145Courtesy of GENERAL MOTORS CORP.
  1. Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  2. Press the tabs on the control cable and remove the cable from the control assembly.
    3. Fig 2: Disconnecting Control Cable From Transaxle Range Switch Lever
    GM1518165Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the control cable from the transaxle range switch lever.
    4. Fig 3: Removing Cable From Control Cable Bracket
    GM1518166Courtesy of GENERAL MOTORS CORP.
  4. Press the 2 tabs on the control cable and remove the cable from the control cable bracket.
    5. Fig 4: Removing Control Cable Grommet
    GM944396Courtesy of GENERAL MOTORS CORP.
  5. Remove the control cable grommet from the dash panel.
  6. Remove the control cable from the vehicle.
About FixVault