Skid Control Sensor: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL SKID CONTROL SENSOR 
   1. Clean the contacting surface of the rear axle hub and a new skid control sensor.
      NOTE: Keep the sensor rotor clean.
   2. Place the skid control sensor on the rear axle hub so that the connector is as low as possible when installed to the vehicle.
      Fig 1: Identifying Contact Surface

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Using SST and a press, install the skid control sensor on the rear axle hub.

      SST 09214-76011 

      NOTE:

      • Do not tap the skid control sensor directly with a hammer.
      • Check that there is no foreign matter on the skid control sensor detection portion.
      • Press in the skid control sensor straight and slowly.
        Fig 2: Installing Skid Control Sensor On Rear Axle Hub

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (See  INSTALLATION  ) 
3. INSPECT REAR AXLE DEVIATION AND BACKLASH (See  INSTALLATION  ) 
4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY 
5. CONNECT SKID CONTROL SENSOR WIRE 
   1. Connect the connector to the skid control sensor.
6. INSTALL REAR WHEEL 

   Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
8. CHECK ABS SPEED SENSOR SIGNAL 
   1. Check the ABS speed sensor signal (see HOW TO PROCEED WITH TROUBLESHOOTING  ).
      Fig 3: Connecting Connector To Skid Control Sensor

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002