Shift Lever: Installation

INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
1. Install the shift lever knob sub-assembly onto the shift lever assembly.
  
  Fig 1: Identifying Shift Lever Knob Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SHIFT LEVER ASSEMBLY
1. Install the shift lever assembly with the 4 nuts.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
  
  Fig 2: Locating Nuts And Shift Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
1. Rotate the transmission control cable nut counterclockwise approximately 180° and, while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.
  
  Fig 3: Rotating Transmission Control Cable Nut Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Push the lock piece up from the back side of the adjuster case while pinching the claws on the lock piece.
  
  Fig 4: Pushing Lock Piece Up
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the cable outer of the transmission control cable onto the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and press in the stopper.
  HINT:
  
  If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.
  
  Fig 5: Installing Cable Outer Onto the Shift Lever Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the control cable to the shift lever.
  NOTE:
  - Make sure the cable is installed onto the base of the pin.
  - Check that the lock piece is pulled up.
  Fig 6: Identifying Lock Piece
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the 2 connectors.
  
  Fig 7: Locating Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADJUST SHIFT LEVER POSITION
1. Move the shift lever and control shaft lever into the N position.
2. Press in and lock the lock piece to the adjuster case.
  NOTE: Securely press in the lock piece until the lock engages.
3. After the adjustment, inspect the shift lever by manually operating it and checking that each position is normal.
  If a problem is found, perform the adjustment again.
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (See INSTALLATION )
INSTALL FRONT NO. 1 CONSOLE BOX INSERT (See INSTALLATION )
INSTALL FRONT NO. 2 CONSOLE BOX INSERT (See INSTALLATION )
INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )