Extension Case: Installation

Attach the selected thrust needle bearing to the end surface of reduction drive gear with Vaseline.
NOTE: Install thrust needle bearing in the correct direction.
Install new gasket.
Install the extension case to the transmission case.
Tighten bolts to secure the case.
Tightening torque: 25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 1: Identifying Extension Case To Transmission Case
Install the rear vehicle speed sensor.
Tightening torque: 7 N.m (0.7 kgf-m, 5.1 ft-lb)
- MP-T model
  
  Fig 2: Identifying Rear Vehicle Speed Sensor - MP-T Model
- VTD model
  
  Fig 3: Identifying Rear Vehicle Speed Sensor - VTD Model
Install the transmission assembly.
< Ref. to INSTALLATION , Automatic Transmission Assembly. >