FixVault
Home › Subaru › 2007 › B9 Tribeca Base › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission (5AT) › Front Differential Assembly › Installation

Front Differential Assembly: Installation

  1. When installing the differential assembly to case, be careful not to damage the inside of case (particularly, the differential side retainer mating surface).
    Fig 1: Identifying Differential Assembly
    G05346547Courtesy of SUBARU OF AMERICA, INC.
  2. Install the O-ring to left and right side retainer.
  3. Using the ST, install the side retainer.

    ST 18630AA010 WRENCH COMPL RETAINER

  4. Adjust the backlash of the front differential. <Ref. to ADJUSTMENT , Front Differential Assembly .>
  5. Install the lock plate.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18 ft-lb) 

    Fig 2: Identifying Lock Plate
    G05346548Courtesy of SUBARU OF AMERICA, INC.
  6. Install the converter case to the transmission case. <Ref. to INSTALLATION , Converter Case .>
  7. Install the transmission harness connector to the stay.
  8. Install the ATF filter pipe. <Ref. to INSTALLATION , ATF Cooler Pipe and Hose .>
  9. Install the oil charge pipe together with an O-ring. <Ref. to INSTALLATION , Oil Charge Pipe .>
  10. Install the torque converter assembly. <Ref. to INSTALLATION , Torque Converter Assembly .>
  11. Install the transmission assembly to the vehicle. <Ref. to INSTALLATION , Automatic Transmission Assembly .>
About FixVault