Basic Diagnostic Procedure

NOTE:

Turbo model is the model with immobilizer.
Non-turbo model is the model without immobilizer.

DIAGNOSTIC PROCEDURE CHART

Step	Check	Yes	No
1 SECURITY SYSTEM SETTING Turn the setting of security system ON. <Ref. to SECURITY SYSTEM ON/OFF SETTING INSPECTION, SECURITY SYSTEM. >	Is setting completed correctly?	Go to step 2.	Check the ignition switch circuit. <Ref. to CHECK IGNITION SWITCH CIRCUIT INSPECTION, SECURITY SYSTEM. > Check the door lock switch circuit. <Ref. to CHECK DOOR LOCK SWITCH AND CIRCUIT INSPECTION, DOOR LOCK CONTROL SYSTEM. >
2 CHECK SECURITY SYSTEM SETTING OPERATION. Before starting this diagnosis, open all doors. Remove the key from ignition key cylinder, then close all doors and rear gate. Press the LOCK/ARM button of keyless transmitter, and wait for 30 seconds.	Can the security system be set?	Go to step 3.	Go to symptom 1. <Ref. to SYMPTOM CHART INSPECTION, SECURITY SYSTEM. >
3 CHECK SECURITY INDICATOR LIGHT AND HAZARD LIGHT BLINKING. Check the security indicator light and hazard light blinking. NOTE: The blinking pattern of security indicator light is twice within 1 second in 1 second cycle.	Does the security indicator light and the hazard light blink?	Go to step 4.	Go to symptom 2. <Ref. to SYMPTOM CHART INSPECTION, SECURITY SYSTEM. >
4 CHECK SECURITY ALARM OPERATION. Unlock all doors using the door lock switch on front door. Open any door or rear gate.	Does the security alarm operate when opening any door or rear gate?	Go to step 5.	Go to symptom 3. <Ref. to SYMPTOM CHART INSPECTION, SECURITY SYSTEM. >
5 CHECK SECURITY ALARM OPERATION. Check the security alarm operation.	Do all security alarm (horn, hazard light and security indicator light) operate? And is the starter motor deactivated?	Go to step 6.	Go to symptom 4. <Ref. to SYMPTOM CHART INSPECTION, SECURITY SYSTEM. >
6 CHECK SECURITY ALARM CANCEL OPERATION. Press the UNLOCK/DISARM button of the keyless transmitter. NOTE: Model with immobilizer blinks once, model without immobilizer is remain off.	Do all security alarm (horn and hazard light) stop? And is the starter motor activated?	Go to step 7.	Go to symptom 5. <Ref. to SYMPTOM CHART INSPECTION, SECURITY SYSTEM. >
7 CHECK BATTERY DISCONNECT PROTECTION. Check that the system functions properly when the battery is disconnected temporally. <Ref. to CHECK BATTERY DISCONNECT PROTECTION INSPECTION, SECURITY SYSTEM. >	Does the system function properly when the battery is disconnected temporally?	Go to step 8.	Replace the keyless control module.
8 CHECK IMPACT SENSOR. Check the sensitivity of impact sensor. <Ref. to CHECK IMPACT SENSOR ADJUSTMENT, IMPACT SENSOR. > NOTE: Perform this procedure only to the vehicle with an impact sensor (dealer OP).	Is the sensitivity set properly?	Press the UNLOCK/DISARM button of keyless transmitter, and finish the diagnosis.	Adjust the sensitivity properly. <Ref. to IMPACT SENSITIVITY ADJUSTMENT ADJUSTMENT, IMPACT SENSOR. >