Parameter Initialization Mode

CAUTION:

Subaru Select Monitor is required for the Parameter Initialization Mode.
This function can be used for replacement parts of the parking brake control module.

NOTE:

When DTC "Parameter selection error" is detected after replacing the parking brake control module, use this function to perform parameter initialization of the parking brake control module.
After performing Parameter Initialization Mode, perform the Force Sensor Calibration Mode and Clutch Sensor Calibration Mode. Refer to , FORCE SENSOR CALIBRATION MODE , OPERATION, Subaru Select Monitor. Refer to , CLUTCH SENSOR CALIBRATION MODE , OPERATION, Subaru Select Monitor.

Connect the Subaru Select Monitor.
On << Main Menu >> display, select {Each System Check}.
On << System Selection Menu >> display, select {Brake Control System}.
Click the [OK] button after {Parking Brake System} is displayed.
On << Maintenance Operation Mode >> display, select {Parameter Initialization Mode}.
The confirmation message, "Perform parameter initialization?", is displayed on the screen. Following the instructions on the screen, confirm the connections of all control modules, and click the [YES] button.
The message, "Parameter initialization in progress-", is displayed on the screen, and initialization begins.
The message, "Parameter initialization done. Turn Ignition Switch OFF.", is displayed on the screen. Turn the ignition switch to OFF to end the Parameter Initialization Mode.