FixVault
Home › Subaru › 2020 › Outback Base › Repair and Diagnosis (Single Page) › Body & Frame › Exterior Body Panels › Power Rear Gate System (Service Information) › Power Rear Gate Control Module › Installation

Power Rear Gate Control Module: Installation

CAUTION: Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
  1. Install the power rear gate Control Module.
    NOTE: Connect the connectors in reverse order of removal.
  2. Install the bracket remote lever LH.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  3. Install the trim panel assembly D pillar LH and the trim panel assembly apron LH. Refer to EXTERIOR/INTERIOR TRIM>Rear Quarter Trim>INSTALLATION .
  4. Install the rear seat cushion assembly. Refer to SEATS>Rear Seat>INSTALLATION .
  5. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
About FixVault