FixVault
Home › Subaru › 2020 › Outback Base › Repair and Diagnosis › Body & Frame › Seats › Seat System - Seats › Seat Heater System › Installation › Rear Seat Heater Control Module › OUTBACK model

OUTBACK model

  1. Install the rear seat heater Control Module.

    Tightening torque: 

    13 N.m (1.3 kgf-m, 9.6 ft-lb)

  2. Install the trim panel assembly apron RH. Refer to EXTERIOR/INTERIOR TRIM>Rear Quarter Trim>INSTALLATION>OUTBACK model .
  3. Install the pad rear side RH. Refer to SEATS>Rear Seat>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
About FixVault