Engine Starting System & Charging System (Except For HEV): Starter: Installation

CAUTION:

When replacing the starter of model with Auto Start Stop, be sure to perform [Start count clearing] after the service. Ref. to AUTO START STOP (DIAGNOSTICS)>WORK SUPPORT .
When replacing the starter of model with Auto Start Stop, be sure to replace the fuel pump relay at the same time. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL PUMP RELAY .

Install the starter and cable stay.
NOTE: For the MT model, a bolt is used in the lower side of the starter.

Tightening torque:

50 N.m (5.1 kgf-m, 36.9 ft-lb)
Connect the connector, terminal B and ground terminal.
Tightening torque:

Terminal B

11 N.m (1.1 kgf-m, 8.1 ft-lb)

Ground terminal

14 N.m (1.4 kgf-m, 10.3 ft-lb)
Install the front wheel LH. Ref. to WHEEL AND TIRE SYSTEM>TIRE AND WHEEL>INSTALLATION .
Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .