FixVault
Home › Subaru › 2021 › WRX STI › Repair and Diagnosis › Transmission › Manual Trans › Manual Transaxle & Differential (TY856) › Driven Gear Assembly › Installation

Driven Gear Assembly: Installation

  1. Adjust the main shaft snap ring. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>MAIN SHAFT ASSEMBLY>ADJUSTMENT .
  2. Adjust the 1st-2nd fork rod. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>SHIFTER FORK AND ROD>ADJUSTMENT .
  3. Install the thrust needle bearing.
    NOTE: Confirm that the thrust needle bearing is installed in the proper direction.
    G05003417Courtesy of SUBARU OF AMERICA, INC.
  4. Install the 1st needle bearing.
  5. Install the driven gear assembly. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>MAIN SHAFT ASSEMBLY>INSTALLATION .
  6. Install the transmission case. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>TRANSMISSION CASE>INSTALLATION .
  7. Adjust the backlash of the driven gear assembly in the axial direction. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>DRIVEN GEAR ASSEMBLY>ADJUSTMENT .
  8. Install the center differential. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>CENTER DIFFERENTIAL>INSTALLATION .
  9. Install the transfer driven gear. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>TRANSFER DRIVEN GEAR>INSTALLATION .
  10. Install the extension case. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>EXTENSION CASE>INSTALLATION .
  11. Install the neutral position switch, back-up light switch and harness. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>NEUTRAL POSITION SWITCH>INSTALLATION . Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>BACK-UP LIGHT SWITCH>INSTALLATION .
  12. Install the manual transmission assembly to the vehicle. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) (TY85)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
About FixVault