How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the power tilt and telescopic steering column system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B:  Go to CAN COMMUNICATION SYSTEM

   A: Go to next step. 

4. CHECK FOR DTC* 
   1. Check for DTCs (See DTC CHECK/CLEAR  ).
   2. Clear the DTCs (See DTC CHECK/CLEAR  ).
   3. Recheck for DTCs (See DTC CHECK/CLEAR  ).

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

   B:  Go to DIAGNOSTIC TROUBLE CODE CHART 

   A: Go to next step. 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B:  Go to step  8

   A: Go to next step. 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Terminals of ECU (See TERMINALS OF ECU  )
   2. Data List/Active Test (See DATA LIST / ACTIVE TEST  )
7. REPAIR 
8. CONFIRMATION TEST 

   NEXT: END