How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the meter / gauge system.
• *. Use the Intelligent tester or Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK FOR DTC* 
   1. Check for DTCs and note any codes that are output (see DTC CHECK / CLEAR )
   2. Delete the DTCs (see DTC CHECK / CLEAR )
   3. Based on the DTCs output above, try to force the output of the same CAN communication system DTC or meter / gauge system DTC by simulating the symptoms indicated by the DTC. Then recheck for DTCs (see DTC CHECK / CLEAR ).

   Result: 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is not output	A
   CAN communication system DTC is output	B
   Meter / gauge system DTC is output	C

   B: Go to CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

   C: Go to DIAGNOSTIC TROUBLE CODE CHART  (See DIAGNOSTIC TROUBLE CODE CHART )

   A: Go to next Step 

4. PROBLEM SYMPTOMS TABLE 
   1. Refer to the problem symptoms table (see PROBLEM SYMPTOMS TABLE ).

   Result: 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B:  Go to step  7

   A: Go to next Step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Terminals of ECU (see TERMINALS OF ECU )
   2. DATA LIST / ACTIVE TEST (see DATA LIST / ACTIVE TEST )
   3. Operation check (see OPERATION CHECK )
6. REPAIR OR REPLACE 
7. CONFIRMATION TEST 

   NEXT: END