Section 39 (Auto-Cruise Control System - 2.0L (Except Evolution & SPORTBACK))
WARNING: This page is about a different variant/trim than selected.
- General Description
- Special Tools
- Auto-Cruise Control System Diagnosis
- Introduction To Auto-Cruise Control System Diagnosis
- Auto-Cruise Control System Diagnostic Troubleshooting Strategy
- Auto-Cruise Control System Diagnostic Trouble Code Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Definitions
- Diagnostic Trouble Code Procedures
- DTC 11: Auto-cruise Vacuum Pump Drive System
- DTC 12: Vehicle Speed Signal System < M/T >
- DTC 12: Vehicle Speed Signal System < A/T >
- DTC 14: Auto-cruise Vacuum Pump Power Supply System
- DTC 15: Auto-cruise Control Switch System
- DTC 16: Auto-Cruise Control-Ecu
- DTC 17: Throttle Position Sensor and Idle Position Signal System < M/T >
- DTC 17: Throttle Position Sensor and Idle Position Signal System < A/T >
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication With Scan Tool MB991958 is not Possible (Communication with the Auto-cruise Control-ECU Only is not Possible.)
- INSPECTION PROCEDURE 2: When the Brake Pedal is Depressed, Auto-cruise Control is not Cancelled.
- INSPECTION PROCEDURE 3: When the Clutch Pedal is Depressed, Auto-cruise Control is not Cancelled < M/T >
- INSPECTION PROCEDURE 4: When the Selector Lever is Moved to "N" Range, Auto-cruise Control is not Cancelled < A/T >.
- INSPECTION PROCEDURE 5: When the Auto-cruise Control "CANCEL" Switch is Set to ON, Auto-cruise Control is not Cancelled.
- INSPECTION PROCEDURE 6: Auto-cruise Control cannot be Set.
- INSPECTION PROCEDURE 7: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed < M/T >.
- INSPECTION PROCEDURE 8: Auto-cruise Control Indicator Light inside Combination Meter does not Illuminate. (However, Auto-cruise Control is Normal.)
- Data List Reference Table
- Check Auto-Cruise Control-Ecu Terminals
- On-Vehicle Service
- Auto-Cruise Control