FixVault
Home › Subaru › 2006 › Impreza Outback Sport, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission › Transmission Control Device › Installation

Transmission Control Device: Installation

  1. Install detent spring to transmission case.

    Tightening torque: 6 N.m (0.6 kgf-m, 4.3 ft-lb) 

    Fig 1: Identifying Detent Spring To Transmission Case
    G05002849
  2. Insert range select lever, and tighten bolt.

    3. Tightening torque: 6 N.m (0.6 kgf-m, 4.3 ft-lb) 

    Fig 2: Identifying Range Select Lever And Bolt
    G05002851
  3. Install the manual plate and parking rod.
    Fig 3: Identifying Manual Plate And Parking Rod
    G05002852
  4. Insert spring pin to manual plate.
    Fig 4: Identifying Spring Pin To Manual Plate
    G05002847
  5. Install control valve assembly and oil pan. < Ref. to INSTALLATION , Control Valve Body. >
  6. Turn over the transmission case to its original position.
  7. Install pitching stopper bracket.

    Tightening torque: 41 N.m (4.2 kgf-m, 30.2 ft-lb) 

  8. Install inhibitor switch and adjust the inhibitor switch. < Ref. to INHIBITOR SWITCH . >
  9. Insert inhibitor switch and transmission connector into stay.
    Fig 5: Identifying Inhibitor Switch And Transmission Connector Into Stay
    G05002854
  10. Install air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
  11. Insert the input shaft while rotating it lightly by hand, and then check the protrusion amount.

    Normal protrusion amount A: 50 - 55 mm (1.97 - 2.17 in) 

    Fig 6: Identifying Input Shaft
    G05002576
  12. Install the torque converter clutch assembly. < Ref. to INSTALLATION , Torque Converter Clutch Assembly. >
  13. Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >
About FixVault